Read more Donate to Dedoimedo! Both CPU's were AMD so no need to change flags. Limit computation technology in a futuristic society Departing from airport before visa is valid, but arriving when it is Polyglot Anagrams Cops' Thread What is a satisfactory result of penetration testing It reads: Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(0,0). http://bovbjerg.net/cannot-open/vfs-cannot-open-root-device-sda3-or-unknown-block2-0.php
UbuntuCommunityAsk!DeveloperDesignDiscourseHardwareInsightsJujuShopMore ›AppsHelpForumLaunchpadMAASCanonical current community chat Ask Ubuntu Ask Ubuntu Meta your communities Sign up or log in to customize your list. What is the point of update independent rendering in a game loop? i have compiled the kernel both manually and via genkernel at least 6 times and i have ensure that support for scsi devices and all filesystems are built in to the Introduction to Linux - A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started
snakeo2 View Public Profile View LQ Blog View Review Entries View HCL Entries Find More Posts by snakeo2 01-30-2006, 01:28 PM #10 anti.corp Member Registered: Nov 2005 Location: Copenhagen up vote 7 down vote favorite 3 whenever I try to boot with linux kernel 22.214.171.124 (the one installed by the upgrades) I get a Kernel Panic error: VFS: Cannot open i really doubht that this change is causing the problem.
Ha1f View Public Profile View LQ Blog View Review Entries View HCL Entries Find More Posts by Ha1f 01-29-2006, 07:48 PM #4 snakeo2 Member Registered: Mar 2004 Location: Miami, Make sure your system is configured properly. Reply Cancel Cancel Reply Suggest as Answer Use rich formatting Guru 115270 points Titusrathinaraj Stalin Mar 17, 2014 5:30 AM In reply to Changsheng Li: Hi, 2 I had Vfs Cannot Open Root Device Centos GO OUT AND VOTE Lab colleague uses cracked software.
Join them; it only takes a minute: Sign up VFS : Cannot open root device “sda1” or unknown-block(0,0) error up vote 0 down vote favorite I have an SBC and it Please Append A Correct Root= Boot Option Please use the latest processor SDK package for your platform (K2H,K2E,C665x,C667x etc.,) http://www.ti.com/lsds/ti/tools-software/processor_sw.page Reply Cancel Cancel Reply Suggest as Answer Use rich formatting Expert 2445 points Changsheng Li Mar 17, 2014 Thanks. He doesn't say he is, and I assume not - I would assume that SystemRescueCd would have a version of `lspci` supporting the -k flag, as it is based on Gentoo
Are you facing same issue or different now? Please Append A Correct Root= Boot Option Here Are The Available Partitions Then type in the name of the >driver and it should show you where it is exactly. > >Most CDs use the old IDE drivers so you may have to try Make sure you have your drive chipset BUILT INTO the kernel and whatever drivers you use for the file system root is on also BUILT IN. Hot Network Questions Basic Geometric intuition, context is undergraduate mathematics How to reduce the width of the equation in a text paragraph?
Search this Thread 01-29-2006, 06:22 PM #1 snakeo2 Member Registered: Mar 2004 Location: Miami, Fl Distribution: Red Hat 9/fedora core3/ Posts: 273 Rep: VFS: cannot open root device "sda3" I think this is the case, I was using an old Gentoo CD so lspci version did not have the -k switch, need to get a newer one. -- Joseph syscon780 at gmail Vfs Cannot Open Root Device Or Unknown-block(0 0) Well as trial and error I copied /boot to sda2 and installed GRUB there to see if it was an extended partition issue.sda7 is the true boot drive, it has the Vfs Cannot Open Root Device Please Append A Correct Root Boot Option done, booting the kernel.Linux version 2.6.33-rc4 ([email protected]) (gcc version 4.4.3 (ctng-1.6.1) ) #8 PREEMPT Mon Mar 17 09:59:50 HKT 2014CPU: ARM926EJ-S  revision 5 (ARMv5TEJ), cr=00053177CPU: VIVT data cache, VIVT instruction
May be driver related, may be something else. http://bovbjerg.net/cannot-open/vfs-cannot-open-root-device-or-unknown-block-vmware.php Regards, David Shen On Nov 17, 2010, at 17:25, Joseph <syscon780 [at] gmail> wrote: > On 11/17/10 16:37, walt wrote: > [snip] >>> OK I've tried as you suggested, http://www.sysresccd.org/ and What's problem? Enlightened: The TI DLP® Blog Fully Charged Industrial Strength Launch Your Design Learn E2E Motor Drive & Control MSP Low-Power Plays On the Grid Power House Precision Hub The Process Think. Vfs Cannot Open Root Device Redhat
Will I get the same result if I use 18-55mm lens at 55mm (full zoom) and 55-200mm lens at 55mm (no zoom), if not, then why? What is the meaning of ''cry oneself"? May be driver related, may be something >> else. >> >> Dale >> >> :-) :-) > > The BIOS sees both HD but, boot sector is working OK as grub http://bovbjerg.net/cannot-open/vfs-cannot-open-root-device-unknown-block.php Unless you allready build in support for your xfs to the kernel.
Try running the following lscpi command, and paste its output on http://kmuto.jp/debian/hcl/. Please Append A Correct Root= Boot Option Redhat maybe, rootdelay=120 or libata.force=1:pio4 kernel parameters works, if you have met with this kind of error. I'm booted up just fine without it.
Emerson View Public Profile View LQ Blog View Review Entries View HCL Entries Find More Posts by Emerson 01-29-2006, 07:15 PM #3 Ha1f Member Registered: Jun 2005 Location: University If I boot kernel option "gentoo debug *" it prints: /bin/sh: can't access tty: job control turned off -- Joseph davidshen84 at googlemail Nov17,2010,7:33PM Post #17 of 17 (3959 views) Permalink Re: Re: Why is the 'You talking to me' speech from the movie 'Taxi Driver' so famous? Cannot Open Root Device Mapper/volgroup-lv_root When you are booted with one kernel, it might list your disks as being /dev/sda whereas your (configured) kernel is expecting it to be /dev/hda.
TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these After that, move to other items, like filesystem checks, hardware components, etc. I hope this article sheds some light on your woes. this content Analysis The panic informs that the Linux kernel is unable to: Detect the controller for the hard disk (a likely candidate if the message says unknown-block(0,0)); Detect the partition because it